Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Submitted byAnonymouson04-08-201908:50 AM
Status:
Gathering Support
Rapid blocking
I was thinking it would be nice if in setup you could select a clamp or anything and have the tool paths always avoid that area like a no go zone. Then I wouldn't have to have my tools always lift high enough to clear, slowing my production times down.
