Fusion
Community
201 Views, 1 Reply
I used the sweep commend under the patch mode, but i cannot finish the job, there is a error popup and the Obutton is not available. in this case, i know i can use revolve, but if i wanna sweep along a closed spline, how can i do? and why it happends? hope to get answer
This is a double post I answered in the other thread here
Mark
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Forums Links
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
