Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Is there a way to modify a single pattern for a part? The reason is; If we wanted to add a drip leg, or an extra bend on one side of the duct. It would be nice to have the abliity to edit the part in the flat. Maybe some more draw tools available in this dialog. See attached image.
The are some times we would like to do 'one off' changes to a pattern. These changes do not need to be in the database. It will likely never get used again. It would be nice if we could make a change at the pattern level, and those changes would only be in that one piece of duct.
Maybe some draw tools, apply a bend. That type of stuff.
There's no access to the notching configuration from CAD. However it is accessible from EST if you happen to have thet.
Typically, most folks who are interested in the notching are also fabricating so they assume they're using CAMduct.
If it's a short term need (set it and be done), you could always download the 30-day trial of EST or CAM and point that to your database configuration and make the needed changes. It'll expire in a month but if typically once you get the notching dialed in, you don't mess with it very often .
