Hypertherm edge pro post processor

[mick1968]

Hi,

     We have recently purchaced a new plasma machine with the hypertherm edge pro controller and are looking

     to use our existing CamDuct software. i am looking for information on what post processors i need and how to install etc,

     the version of cam duct is around 2009 which i think has only two post processors available.

     any info on this would be apprieciated.

     regards.

[Anonymous]

These will work for the Hypertherms...

D6GEN.vpl / D6GEN64.vpl

As for setup, that's going to be more machine dependent than anything.

[davedykes]

Hi Mick

You will still be using the Dongled software and the Post Processors were limited to what was purchased.

The new Autodesk Fabrication CAMduct unlocks all the Post Processors and makes them freely available, as Darren has said, the D6gen is the Post you would need to use.