@Radius command get error message when routing 'Signal not found'.

[dmitri.weintraub]

Hello together,

I design very many PCB that are round.
Until Eagle 9.3 I could while I had the route command enabled. Just put in the command line e.g. "@+15".

Then a straight line became an arc.

Unfortunately, this command no longer works properly with the new Eagle versions.

It works only with Net and Line command.

With the Route command I always get an error.

[dmitri.weintraub]

Hello together,

I design very many PCB that are round.
Until Eagle 9.3 I could while I had the route command enabled. Just put in the command line e.g. "@+15".

Then a straight line became an arc.

Unfortunately, this command no longer works properly with the new Eagle versions.

It works only with Net and Line command.

With the Route command I always get an error.

[jorge_garcia]

Hi @dmitri.weintraub ,

I hope you're doing well. This functionality was dropped from the routing engine some 2 years ago. You can change to a curved trace style by holding ctrl and right clicking to cycle through the various bend styles until you get to the curved styles.

Let me know if there's anything else I can do for you.

Best Regards,

[jorge_garcia]

Hi @dmitri.weintraub ,

I hope you're doing well. This functionality was dropped from the routing engine some 2 years ago. You can change to a curved trace style by holding ctrl and right clicking to cycle through the various bend styles until you get to the curved styles.

Let me know if there's anything else I can do for you.

Best Regards,