Missing a resistor in an array

[johnwYMVVZ]

I have a 4-position resistor array where the first 3 positions are filled, but the last one doesn't show up anywhere.  How do I get that last one to show up in the schematic editor so I can fill it?  When I add the array as a part, it adds the resistors one at a time, so I've tried adding a single resistor as a new part and renaming it to be part of that old array, but get the "name exists" error.

Probably just need to delete and create a new array, but it would be nice if there were a way to deal with this situation.

[rachaelATWH4 · Accepted solution]

Hello,

You need to use the INVOKE command using the name of the existing part. So for example, if the resistor pack you have use 3 and have 1 spare is RN1 then you would use:

INVOKE RN1

From the EAGLE command line and it'll pop up a window listing the gates in the part allowing you to choose and place the unused gate.

Best Regards,

Rachael