How to setup defaults for all auto routing variants to avoid top layer

[Eradicatore]

Hi,

I've learned how to avoid the top layer, but it required manually adjusting all the many tabs of this dialog for a given variant, to increase the cost for "Top" layer to something like 9 to make the auto router use the middle of the 4 layer board.  Is there a simple way to just set a default value for all instances of "Top"?

Given the fact that there is a default for Top and Bottom of 0 already, I'm hoping the system has a way to change this default.  🙂

[jorge_garcia]

Hello @Eradicatore,

I hope you're doing well. You can save the configuration once you have it fully setup by going to the general tab and clicking save as. Whenever you want to use it just load it in the general tab.

Let me know if there's anything else I can do for you.

Best Regards,