Fusion 360 Sync

[circuits4ever]

I tried pushing my 3D file to Fusion 360 and with the Fusion Sync feature and it was perpetually cranking it out until I had to sleep and close EAGLE completely. The next day the Fusion Sync says "PUSH IN PROGRESS" but it never finishes.

Is there something wrong with the Fusion Sync that will be patched later, or am I doing something wrong? I used to be able to push 3D designs with this feature in a previous version of EAGLE. 

Thanks!

[jorge_garcia · Accepted solution]

Hello @circuits4ever,

I hope you're doing well.

It's been a few days since your first post. Try pushing again, does it still not finish? If it doesn't try pushing to a fresh project in Fusion360.

Best Regards,

[circuits4ever]

No, I tried it multiple days and it wouldn't finish. How do I push to a fresh project? Won't it still give me "Push in progress"?

[circuits4ever]

I did a push to a fresh project and it worked, thanks!