DRC - All Trace Widths Causing Errors

[tedj1]

Hi.  I had a PCB that produced no errors in the DRC, until this morning when I opened it and all kinds of errors.  Primarily, all traces are generating Width errors.  Most all of mine are 10mil.  The rest are 6 mil.  I run DRC again.  Under the Sizes tab, the Minimum Width is set at 6mil.  I Apply and run the check.  Yet, all of those Width errors still show.  I can't understand what I must have changed, or what I'm doing wrong now and surely there's no Max Trace Width limit, although I did just upgrade to ver 9.5.0 from 9.4.2.  Confused.

[rachaelATWH4 · Accepted solution]

---

@tedj1 wrote:

Under the Sizes tab, the Minimum Width is set at 6mil.  

---

Also check in the net class setup that nothing has changed there as the net class will override the DRC defaults.

Best Regards,

Rachael

[tedj1]

Thanks.  That was it.