I am trying to develop a block for a fiber optic input/output card with 8 input/outputs on each card. Each input/output can be configured in 1 of 3 ways, Unidirectional (State #1) Bidirectional on the left hand side (State #2) or Bidirectional on the right side (State #3).
In addition, there can be up to 40 input cards in a card chassis, so the input/output values (up to 320 in multiples of 😎 and card slot numbers (up to 40) would also need to change using a separate drop down arrow.
I'm looking to put a drop down arrow on each of the inputs/outputs of the card to toggle between the 3 states and another drop down to change the input/output values (in multiples of 😎 and card slot values.
I have attached a file, with a visibility state to change the input/output and card slot values, but cannot figure out how to change the 3 states of the card configuration.
I'm certain there is a solution to this but I have not been able to figure it out.
Any help would be appreciated.
