Lookup Dimension

Sujan.Maharjan · ‎03-05-2017

Hi,

I added Linear dimension property in Lookup. But for some I want that to be (AS IT IS/UNCHANGED).

Autocad does not allow reverse lookup without putting any value.

"Revit Lies in the tension between what we want to do and what can be done!"

ojuris · ‎03-06-2017

hi!

I don't understand what you mean

Could you explain a little more precisely?

Sujan.Maharjan · ‎03-12-2017

I mean how to leave blank in highlighted area for Duct length parameter with reverse lookup enabled.(attached screenshot)

"Revit Lies in the tension between what we want to do and what can be done!"

marco_martinez · ‎03-13-2017

Hi

May be you could send an image of your block or your block so I can help you

Libbya · ‎03-13-2017

I am quite sure I can offer a solution if you post the block.

Emmsleys · ‎03-31-2017

Following up on your thread, were you able to find a solution or a workaround?

Did any of the posts in the thread help with the issue?

Please use the Accept as Solution for those post’s that helped. It may benefit other users who might have a similar question or issue.

Thanks for your time.

Sarah Emmsley
Technical Support Specialist

Community