Dynamic Block file to large, acting strange

[james.swinfield]

Hi,

I have created a Dynamic TB for a project we are doing, I didn't relise until I was about to send that the file was 116MB.

I searched your forum and found threads about DGN lineweights and this morning I have been through every way I can to purge this drawing file:

-PURGE

PURGE

AUDIT

OVERKILL

and so on...

I have the file down to 8MB, which I feel is still to large for what it is. I have also noticed if i edit the block, change the disclaimer in someway by changing the wording a bit, then resave, the file is now 24MB?

Please help. I really dont want to have to create this again.

Best Regards

Jim

[james.swinfield]

Hi,

I have just removed my logo (I had done this earlier but with my rushing to get it out the door I think I may have forgot to delete them from the portriat visibility state) and the file is now much smaller 72kb.

could you tell me the best way to insert a logo in a dynamic block please, but it still be embedded.

Cheers

Jim