Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Hello, I would like to know, If there is a chance to array this block *attached to array but to both directions up and down and keeping the middle holes at center point (insertion point) So basically what I want to do with that block is to place it on center line so middle holes stays on center line and I will be creating copies of holes each direction up and down by 32mm increments. I am doing it just do one direction UP and then I mirror whole block. But would be cool to have it arraying up and down.
