Create T fittings and elbows for Gravity Pipe Networks

[maroua.g]

It would be very helpful if T fittings and elbows for pipe networks could be created as a structure just like pressure networks. 

[TimYarris]

Thank you for your idea. The development team will review this idea while customers continue to add feedback and vote on it.

[doni49]

I would appreciate this very much.  We quite often need to run a 4 inch pvc lateral from our building to the sewer main.  Unless the span between the building and the first change in direction is greater than 150 ft, we do not need a manhole -- a 45 degree elbow is typically used.  But C3D currently does not allow for this -- I always end up placing a NULL STRUCTURE in lieu of the elbow.

[pceg]

We are designing a stormwater system with large diameter pipe, we are installing Tee's as access points verses junction boxes for access points only.  Works great, except we cannot install them because the software does not support.

[choen]

every project I have gravity flow draintile and could really use the bends/tee/cleanouts/and reducers. right now it's all null structures with autocad blocks to show them correctly.

[jeffery.sun72673]

In a lot projects, when I was modelling pipe networks, I met the same problem with tee and elbow, vertical or horizontal. 

[ADominguez]

it would be very useful

[Gamalabubakrr]

it would be very helpful, please consider.

[lgillespie726]

Might as well add my two cents. ADS Inserta Tee would be a perfect example of these being extremely helpful.

[JOKO_]

Would love to have a wye connection that is able to rotate, and, like others said above, horizontal and vertical bends at factory angles (45, 22.5, 11.25).