Community
Hello, I'm setting up a project that is more akin to a surface water/urban river network that contains open channels, and using junctions to indicate any changes in elevation/etc. Invert elevations of junctions and channels are matched and rim elevations are set to the top of the channel (Channel is a user defined irregular cross-section). However, when I run the model, I get surcharging at the nodes/junctions without water appearing to be passing along through the next network link as you see below:
This seems strange to me and I'm hoping you can give me a sense of what might be happening? I'm also attaching an image of some additional project settings:
ANy insight would be greatly appreciated!!
Forums Links
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
