Multiple Corridors that target each other

[wgaerdes]

I have a meandering channel (1st corridor) with a walkway on the one side (2nd corridor) and rear yards on the other side (3rd corridor). I'm having a hard time modelling this since there are a lot of variable. For example if the meander is close to the walkway there would be a wall, otherwise there would be a 2% slope towards the channel. On the rear yard side there could be a wall when the meander is close to it or a 2% slope towards the rear yard and a 3:1 slope to the channel.

I'd appreciate any suggestions to solve this please.

[VincentSheehan]

Could extracting the Feature Lines from one corridor and target the Feature Lines with the other corridor? Keep the Feature Lines dynamic. 

[nkiakas]

Hi @wgaerdes

This one loos like have to make you own subassemblies in SAC

When the typical section has "if...then", because you said if its close, then 2%, otherwise something else.... means you need your personal subassembly(ies).

Give me please more information regarding your typical section

[wgaerdes]

Hi @nkiakas 

Here's the subassembly I have created for the channel. Apparently they don't allow *.pkt file to be attached. 

[nkiakas]

Can you attach it?

[Udo_Huebner]

Please upload additionally a DWG file instead of only a JPG file. And you can upload almost all file formats if you just zip them.

[wgaerdes]

Hi Udo

Here's my drawing

[Jeew-m]

I think you should go with conditional horizontal target assembly in this scenario.