Multileader Style Tab without Using Manager to Set Current Mleader Config

[Anonymous]

s it possible to match the Multileader selection to set the configuration different in 2018, rather than having to open the manager, select configuration and then 'set current'?

I like how easy it was in 2014, but perhaps my CAD manager set this up differently when we moved to 2018.

2014

2018

 

[cwr-pae · Accepted solution]

That section of the annotate tab of the ribbon still exists. There are also two tool bars with the control list. (Styles and multileader)

[Anonymous]

Can you provide direction to enable the ribbon if not configured properly? Or point me to where I might turn this on?

[jeff_rivers]

@cwr-pae I'd like to know where this toolbar is hiding too. I searched the CUI for it, but didn't find it. 

[cwr-pae]

[cwr-pae]

CUI - Its a little confusing to use at first, but a little reading/research in help should guide you through the procedures.

[cwr-pae]

If you have a tool bar loaded, right click in the grey area, pick ACAD and you can find them that way also (can't screen capture the menu when its open)