Mill and Overlay Subassembly

[dcarucci]

Is there a subassembly that you can grind and overlay 2" from the existing surface and hold the existing slopes. It seems the only options has the overlay going back at a design slope not matching existing.

[ecfernandez]

Hi @dcarucci, I am not sure there is a subassembly to do that. However, I am sure you can program a subassembly with Subassembly Composer. You should give it a try. If you do so and you have any questions about it, please post them here in the forum to help you.

Best Regards! 

[Joe-Bouza]

OverlayMill2 matches existing 

these subs are very dependent on the acuracy of your survey and where you define the trim point

[Joe-Bouza]

Rehab subs Mill and overlay