Key-in Command Issues

[DeaconDave]

Civil 3D 2014 isn't reading my commands fast enough.  It's not like I'm some super star typist but when I type "PL" then enter in C3D2012 I'm asked to specify start point but in C3D2014, typing at the same speed and same command, C3D wants to give me a high five or just wants me to PAN.  Another example is the Extend command.  I type "EX" then enter and C3D2014 assumes the Erase command.  Is there a way to fix this?  It's extremely annoying, especially when I'm in a hurry to get a project out of the door.

Thanks in advance.

[gccdaemon]

Turn off Autocomplete. Right click on the command line and expand input settings, then uncheck Autocomplete.

[doni49]

Set AUTOCOMPLETEMODE = 0.  That will completely disable autocomplete.

[DeaconDave]

Andrew / Don - I appreciate your quick responses.  However, my Autocorrect has been disabled.

[DeaconDave]

"AUTOCOMPLETEMODE" comes up as an unknown command.

[doni49]

Not AUTOCORRECT.

It's AUTOCOMPLETE.

[DeaconDave]

I'm sorry, my Autocorrect is active. My Autocomplete is what I have had disabled all along.

FYI, today it seemed to have gotten worse as the day progressed. Maybe because I was focused on it more than usual by watching for replies to this thread. I don't know but it's driving me crazy.

[ToddRogers-WPM · Accepted solution]

How I fixed mine is to go into the Input Settings (click on the little wrench on the command line) and set my milliseconds to 800.  It's weird because at first I set it to a lower number and it was worse.  I think the default is 300. 

[DeaconDave]

Todd - Thank you, sir.  So, far this appears to have been the fix.