Irregular layer shapes

[MattCichon]

Hi Guys,

can anyone tell is it possible to construct something like this, using just the base subassemblies?

Thanks for any ideas.

Greetings,

Matt

[jroot]

Is this a cross-section view or profile view?

Any more description of the end goal you're looking for?

[MattCichon]

Yes,

this is a section view, more to say a standard section view.

I want to build the slopes on layers in the red square.

[jroot]

Interesting... does it have to be "layered" like that or can it just follow the slopes?

Is this like a hollowed out subsurface?

[MattCichon]

It has to be layered like that and the layers should follow the slopes. I can cut the layers perpendicularly, but i was wondering if there is an option to build something like this 🙂

It's a construction on a airport. And is done like that in construction causes...

Thank You.

[jroot]

I've never done an assembly like that and not sure it would work, but it looks like you can stack Basic Lanes like this:

[MattCichon]

So just perpendicularly? No slopes? I've seen something like this on YT, I mean that cross section, done in Microstation InRoads. But never seen something like this in C3D. The layers are from the same material, but they have different thickness.

Thanks,

Matt

[jroot · Accepted solution]

This?  The sloped ones are "ShapeTrapezoidal" with a slope of 0%, then change the inside and outside depths to what's needed, then tack on a BasicLane.

[MattCichon]

Could You please attach the *.dwg file in here?

[jroot]

Here is a DWG with just the assembly I created

[MattCichon]

OK, thank You very much.

Please look at the printscreen. It's a pity that it's impossible to build this shape in just one layer...

Thank you once more.

Greetings from Poland,

Matt