I am trying to figure out how to add "code" for labeling purposed to a link on a specific subassembly? How do I go about doing this? Thanks.
Hello El,
I know this topic is a bit old and I just happened to stumble upon this now. So im trying to create a link on the top of my "LaneSuperelevationAOR" as I want to show a shaded view in my corridor. Since I have the exact same Link Codes in both my "LaneSuperelevationAOR" & "ShoulderExtendAll", i need to create a ghost link on the top of my "LaneSuperelevationAOR". As shown in the image attached, I followed your instructions and seems like my "LinkToMarkedPoint" is not targetting the "MarkPoint"
Use a Mark point and link to mark point
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
@Anonymous Is that Syd in you profile pic? 😎
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
no attachemnt
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Here you go Joe... its the same attachment as my original post yesterday. As you can see my LinkToMarked Point is not tying into the Marked Point and instead, it goes past that point.
My bad @asankaHW the layout mode of the assembly is confusing that way.
1. place MP and name it
2.place link 2MP assign MP name
3. update corridor
4.update codeset with import codes ( reselect your assembly
5. style the new code accordingly
6. shade should work by now
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Can't find what you're looking for? Ask the community or share your knowledge.