found a bug in offset alignments 2023

[alistair.stewart]

have discovered what I think is a bug in the offset alignment vertical profile.

1. I added stations with different offset parameters to my alignment. so far so good. (ch0 - 15 0% ch15 - 25 2% ch25 -ch125 2% ch125 - ch130 0.5% etc)
2. viewed my corridor in the section editor to see the change in cross fall with targeting offset alignment vertical profile, crash! after crash when entering the section editor.
3. remove all added stations from the offset alignment profile properties dialogue box... section editor and drawing stable again. 

is anyone else experiencing this problem?

regards.

Alistair