Editing Graph- Multiple Section Views

[Anonymous]

I have generated Multiple Section Views from 2 overlapping surfaces (proposed & existing) using sample lines.
I need assistance with editing the section views graphs.
- need to change the colors of the data shown on the graph
- need to change the range of the elevations shown on the graph.
- need to be able to update the sample lines every time I am opening the dwg.

Anyone familiar with this case?

Thank you in advance!

[Jeew-m · Accepted solution]

Hi,

These are my suggestions.

- need to change the colors of the data shown on the graph 

Go to section view group properties --> sections tab --> Styles column

- need to change the range of the elevations shown on the graph. 

You cant change it as a group. You need to do it as individual section views

- need to be able to update the sample lines every time I am opening the dwg

Make the corridor/surfaces as Rebuild Automatic

Thanks

[Anonymous]

Thank you so much Jeew!
About the elevation range,  I need to present view sections for more than 8000 feet with the appropriate elevations shown. It will be time comsuming to generate individual views for every sample line.
Attached is a printscreen. On the left praph is the desired elevation range but autocad generades the graph on the right. 
Any ideas on how to proceed?  

Thank you for your patience!

[wfberry]

I cannot walk you through this but if you can generate one section you can generate all sections at once.

(It normally takes me some trial and error before I get it like I want it.)

Practice changing the various styles, etc. with just a few sections until you get it like you want.

Bill