is there a way in C3D to create an encasement pipe. Basically a pipe inside a larger pipe. Both pipes would have to have the same slope, so they look parallel in plan and profile. Thanks
MKH
thats a great tutorial, but I am looking for more of a "conduit" type encasement pipe. Where a pipe is inside a pipe. Thanks again.
KH
Thanks Paul...what a fantastic article. I'm diving into that as soon as possible...bravo!
You can just draw a pipe in plan using a larger dia for the encasement & then project that to your profile & adjust the invert elevations (graphically) to center the encasement pipe over the pipe in profile
Paul
We just did this last week or so and there are a few ways
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
is there a way to cross hatch the entire pipe, not just the walls? Thats how I typically show my encasement. Thanks
MKH
Can't find what you're looking for? Ask the community or share your knowledge.