corridor surface won't triangulate properly

[alexRR6ZB]

This has been driving me crazy for hours and I need to move on from this soon.

I have corridor model that I am happy with and no combination of links or feature lines will result in a good surface.

the corridor

this is driving me crazy. please help. Thanks in advance

[alexRR6ZB]

This has been driving me crazy for hours and I need to move on from this soon.

I have corridor model that I am happy with and no combination of links or feature lines will result in a good surface.

the corridor

this is driving me crazy. please help. Thanks in advance

[alexRR6ZB · Accepted solution]

DONOT use an offset alignment as a target and a baseline simultaneously. It will result in overlapping geometry that will ruin your surface definition. It would be nice if it were possible to target adjacent assembly insertions but it does not appear possible as far as i can tell.

[alexRR6ZB · Accepted solution]

DONOT use an offset alignment as a target and a baseline simultaneously. It will result in overlapping geometry that will ruin your surface definition. It would be nice if it were possible to target adjacent assembly insertions but it does not appear possible as far as i can tell.