Can't navigate model space after using drive

[connor.daviesXY4Z8]

Hi

I just used the drive command on an alignment and profile which was a nice feature, but now in model space, I am unable to pan/zoom around. If I try to move, it snaps back to a fixed position.

I have uploaded a screencast below to illustrate the issue.

Thanks.

[Dexterel]

check if you are not stuck in driving mode.
In driving mode your view is fix at a specific station.
Run command AeccDriveClose
First time you run the command you should get "Not in drive mode."

[connor.daviesXY4Z8 · Accepted solution]

I ended up fixing it, I'm not sure how though...

Also, here's the screencast that I didn't upload. Perhaps it might indicate what I was doing wrong