Announcements
Autodesk Community will be read-only between April 26 and April 27 as we complete essential maintenance. We will remove this banner once completed. Thanks for your understanding
Announcements
We are currently migrating data within this board to improve the community. During this process, posting, replying, editing and other features are temporarily disabled. We sincerely apologize for any inconvenience caused and appreciate your understanding. Thank you for your patience and support.

A few Pipes Missing from Pressure Pipe Network

jrjacksonR8WHV
Explorer Explorer
1,615 Views
4 Replies
Message 1 of 5

A few Pipes Missing from Pressure Pipe Network

jrjacksonR8WHV
Explorer
Explorer

In Civil 3d 2022 I created several pipe runs for water lines. Later, I had to go back and lower a portion of one of the pipe runs to avoid some storm sewer. The pipes and fittings I lowered are the only ones not showing in the pressure pipes list or in the fittings list in Prospector. They are the same style as everything else and part of a pipe run. Why are they missing?

Reply
Reply
0 Likes
Accepted solutions (1)
1,616 Views
4 Replies
Replies (4)
Message 2 of 5

Megan_Eide
Explorer
Explorer
Accepted solution

Same thing just happened to me and I think I fixed mine. Check the source dwg and make sure that part is listed in toolspace. If not, refresh the pipe network (right click in toolspace). Then save, sync references, and refresh the pipe network in that dwg. Hope that helps!

Reply
Reply
0 Likes
Message 3 of 5

jrjacksonR8WHV
Explorer
Explorer

I went back to the source drawing and there were two pipe runs on top of each other. I deleted the second one, refreshed the pressure pipe network, and synchronized and everything showed up.

 

Thanks!

Reply
Reply
0 Likes
Message 4 of 5

RCassel84
Participant
Participant

I have pipes that do not show up in my Network, but when you right click to edit network it calls out the network. I only have 1 network in the drawing but can not seem to figure out why they are not tied to the network. i first noticed it when I data referenced the network in another dwg.

Reply
Reply
0 Likes
Message 5 of 5

gjeppesen
Enthusiast
Enthusiast
Did you ever figure this out? Seems to be a glitch.
Reply
Reply
0 Likes