2 Corridor issues

[michaelV7UU9]

I am creating a corridor that targets BLVD offsets to inside sidewalk alignment and then has a standard 6' wide S/W. 

1-For some reason, the middle of the corridor is not following that code. 

2- the surface created from the corridor does not fully fil the corridor, but instead peters out oddly. 

Happy to supply more info if needed.  project due in 2 weeks and I'm trying to get a jump on this before the new year.  Any help or suggestions would be great. 

[tcorey]

Can you post your drawing?

[michaelV7UU9]

Here is the CAD file. also of note, when I pull the corridor to the end of the alignment on the east end, the surface drops to zero(0).  Appreciate anything you might come up with.

[Jeff_M · Accepted solution]

The sidewalk issue is due to your 2 target alignments cross into the curbs. Edit them so they do not cross and all will be well.

The tapering surface is due to one of the Surface Boundaries definitions having the Reverse option checked. Uncheck this to get the surface to create correctly.

[michaelV7UU9 · Accepted solution]

Thanks. I fixed the sidewalk but am unclear where I uncheck the reverse option. I did remove the boundary and that solved it but that the surface is outside the corridor. Can you describe where i uncheck the reverse?

[Jeff_M · Accepted solution]

[michaelV7UU9]

Thanks. I noodled around and found that.  It was automatically checked and I did not know that field even existed. learn a lot thru this and am grateful for your assistance.