I would like to be able to adjust the number of iterations during solving so I can cause the simulation to terminate earlier or later than originally intended, but not necessarily right now.
So if I originally asked it to run 1000 iterations, but based on how I see the solution evolving now I want it to stop at 500, I would like to be able to enter that during solving.
This could be useful during automatic mesh adapatation cycles where the convergence is happening sooner or later than expected. I may want the current cycle to terminate soon so it can go to the next mesh level.
Alternatively if I underestimated the number of iterations then I would like to be able to extend the run time without starting and stopping the simulatin - this is especially important for large files/remote solves.
Being able to adjust other termination parameters while solving would also be useful (i.e. stop time in a transient, as opposed to iteration number; adjust the intelligent solution parameters to looser or tighter criteria; etc.)
