Simmetry after fill void

Simmetry after fill void

Anonymous
Not applicable
826 Views
1 Reply
Message 1 of 2

Simmetry after fill void

Anonymous
Not applicable

One way to simulate this air blower is build surfaces up and down, and then fill void.

The massive number of holes creates a huge mesh. This model is symmetrical in two planes and it's possible to get results only studying a quarter.

 

If I import only a quarter of the model from PTC Creo, how is the way to fill the void? It's possible?

If I create a surfaces, CFD don't recognize them.

0 Likes
Accepted solutions (1)
827 Views
1 Reply
Reply (1)
Message 2 of 2

Jon.Wilde
Alumni
Alumni
Accepted solution

Hi,

 

You can and absolutely should do this (great approach!) but it needs to be done in Creo. Use a couple of blocks to seal the model off. If you bring through a hollow but sealed model, CFD will fill it for you automatically, easy 🙂

I tend to make the inlet and outlet extensions solids in CAD too, then just make them a fluid in CFD.

 

Check out resistances too, a different tactic that could be useful.

 

Hope that helps,

Jon

0 Likes