I have created a simple model in Fusion 360 and have run a simulation with an exterior fire source in an attempt to show the effect a fire will have if fire were to spread from a neighboring building.
I have got to the point of running a simulation over 1200 steps (20 minutes real-time) to show temperature and smoke concentration. I would like to use planes and iso surfaces to express my findings.
Why is the model not displaying at all after I've run the results? I attach two screenshots below for comparison:
A- In Setup view
B - In Results (Global) view
Solved! Go to Solution.
Solved by s2437321. Go to Solution.
Can't find what you're looking for? Ask the community or share your knowledge.