Symbols Auto scale

[Mohammadjamali75]

Hi Dears ,

 I have struggle with symbols in Plant 3d (Iso)  and P & ID !!!

After Define new symbol in Project and attend it to an object for Take isometric Draft 

unfortunately it's scale doesn't match to other object  and i have to edit  iso again .

also all symbol dimension set according to suggested Dimension  by Manual or native Symbol exist in Data base !!!

please guide me for Solve this issue .

thank you 

 

[h_eger]

Dear @Mohammadjamali75 ,

Attention:

P&ID symbols have absolutely no influence on the ISO symbols.
Both symbols must be configured for the respective area (P&ID or ISO).

[kepinski]

All object should be made with same units.
Command: dwgunits. Don't use imperial units or you have to rescale all blocks. Have you checked dwg units in *.dwt file ?

[Mohammadjamali75]

Hi - Firstly i am thankful For ur attention .

secondly : i know that P&ID IS separate From Plant 3d  

i can Set P&ID New Symbol  with Originals but in 3d plant, it is impossible  😑😥

[Mohammadjamali75]

Hi , thank you for attention .

all  Iso object or P & ID object must build in unitless mode and then use scale factor for them 

[Mohammadjamali75]

 This is a sample 

[Mohammadjamali75 · Accepted solution]

Solution :

have in mind that :

Before start Drawing Symbol Set ur File Unit on [ Unitless]

Secondly : Your Symbol Most has 1.5*1.5 unitless  dimension 

Third : Flanges most Drawing in 0.5 unitless Dimension 

Fourth: In P&ID Symbols Scale is 10  and 3d plant Iso   Scale is  20 

after These u could approve to Suitable Iso Format