Custom 3D Block Based Support issue.

[popovUS9BY]

Hello Colleagues,

I tried to create custom point/anchor support using "ConvertSupports", but pivot/connection point far is far away 3D block.

Support is not connected to the pipe and does not appear in iso sketch.

How can I make pivot/connection point where it should be also support to be part of the pipe?

Supports are for CS150 spec pipe diameter of 125/5".

3D block is attached.

Regards

[h_eger · Accepted solution]

@popovUS9BY ,

Please adhere to all rules for creating block-based supports.
1. insertion point of the block = 0,0,0
2. set shaded mode when creating from the block into a support so that it works with the insertion point in Plant 3D.
3. Complete all data in the properties window so that something arrives on the iso

[popovUS9BY]

Hello h.eger,

thanks for reply!

I played a lil bit with coordinate system and third try (red one) became successful!

Support appear also in ISO's BOM - great!

Danke for your support!