SDF Changes when zoomed in and out

[Anonymous]

The SDF shown below Zoomed In is displayed properly.

The SDF file Zoomed Out one level is missing a portion of the yellow line.

When I zoom out one level, a portion of the SDF does not display.  This same portion will not print to DWF either.

If it were a SHP file I would delete the *.IDX file.  I tried REGENALL and REFRESHING the SDF file.  Anyone have any other suggestions, Thanks.

Dan

[Murph_Map]

SDF files also have the IDX file you can delete.

[Anonymous]

Thanks Murph for that information, but where does AutoCAD Map put this IDX file for the SDF file.  Is it only available when the file is open?

[Murph_Map]

---

@Anonymous wrote:

Thanks Murph for that information, but where does AutoCAD Map put this IDX file for the SDF file.  Is it only available when the file is open?

---

Should be in the same folder as the SDF file if there is one. You can also try to save the sdf layer to a layer file (xml format)when you are zoomed in where it displays the missing segemnts then load that sdf layer to see if that works. Another trick I do is disconnect then reconnect to the file.

[Anonymous · Accepted solution]

Thanks Murph

I saved the SDF to another SDF and for some reason the file size was smaller.  However when I connected to the new file, it displayed properly.  Therefore the solution for me was to remove the existing connection and reconnect and restyle.