This is my first time creating a .pat file from scratch. Can anyone tell me where my error is? Nothing shows up when I load the hatch. Below is the body of my .pat file and the file name is europeanledge.pat.
*europeanledge
00.00, 00.00,00.00, 00.00,01.50
90.00, 02.50,03.00, 41.00,00.00, 01.50,-03.00
90.00, 10.25,03.00, 41.00,00.00, 01.50,-03.00
90.00, 11.75,01.50, 41.00,00.00, 01.50,-03.00
90.00, 13.25,00.00, 41.00,00.00, 01.50,-03.00
90.00, 19.25,00.00, 41.00,00.00, 01.50,-03.00
90.00, 23.00,03.00, 41.00,00.00, 01.50,-03.00
90.00, 30.75,03.00, 41.00,00.00, 01.50,-03.00
90.00, 32.25,01.50, 41.00,00.00, 01.50,-03.00
90.00, 33.75,00.00, 41.00,00.00, 01.50,-03.00
90.00, 39.75,00.00, 41.00,00.00, 01.50,-03.00
Solved! Go to Solution.
Solved by Kent1Cooper. Go to Solution.
Change all your
41.00,00.00,
portions to the other order:
00.00,41.00,
because those displacements are in X and Y terms relative to the rotation angle of the lineset, not relative to 0 degrees.
Can't find what you're looking for? Ask the community or share your knowledge.