when i move a dinamic block , my hatch loose is bondary.

[Anonymous]

Hi , I'm using autocad 2019 and my problem is when I copy and move a dinamic block in the same drawing to another place I loose the bondary of the hatch where the block was previously . it only seem too do that when i use the move command.I used the choose point for the hatch since i didnt start the drawing and its already full of single lines.the block is nothing fancy its juste a detail bubble with a ''clean'' that hide whats under it .

[pendean]

Does this happen in ALL files, or just this one?
Does this happen with ALL dynamic blocks, or just this one?

What does ABOUT command list as your 2019 version? The most current is 2019.1.2, if that is not what it shows you have an update to install.

[Anonymous]

We add the same problem in the other files too.

So far yes its only happeing with this block , the only other dinamicbloc are level and arnt on the hatch itself and when i move them the hatch saty the same .

My autocad version is  2019.1.2.

[pendean]

>>>... its only happeing with this block...<<<
Post a DWG file with the problem block in it please.

[Anonymous · Accepted solution]

can't share the files , since it have some confidential information on it.

I've spoke with some of my IT and the way we found too fix it is to do some polylign and block. When we do that the problem doesnt hapen anymore. Dont really understand why , but i think its less demanding on the software or easier  for him too understand the boundary.So from now on i'll stay away from the choose point hatch option and stick to selection...