Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Viedwcube rotation

Anonymous

Viedwcube rotation

Anonymous
Not applicable

Using World UCS from start of new drawing. all of a sudden i notice the viewcube is 90 degrees  out of rotation. is there a fix to get it back to where it should be?

 

0 Likes
Reply
Accepted solutions (2)
962 Views
15 Replies
Replies (15)

Anonymous
Not applicable

Verify the viewcube is set to WCS, with the below option.

 

2015-01-26_13-13-11.jpg

Anonymous
Not applicable

Thanx for the swift respons jclaider! But yes it is set to WCS.

0 Likes

Anonymous
Not applicable
Accepted solution

In AutoCAD type DVIEW, (hit ENTER twice), then TW.  Reset to 0.

 

Anonymous
Not applicable

no go, but i did jujst copy the elements in ths model and paste to a new drawing, used the design center to drag and drop the layout tabs and now its okay. still am curious as to why this happened.

0 Likes

Anonymous
Not applicable

The DVIEW process usually works, I replicated it on my AutoCAD.

Using the TWIST option rotates the viewcube.  Did the viewcube rotate at all?

0 Likes

Anonymous
Not applicable

it didnt budge. I uploded the file. when open the Viewcube north should be screen right

0 Likes

Anonymous
Not applicable

Is this what you wanted?  (see attached)

 

 

0 Likes

Anonymous
Not applicable

no, the cube is still 90 deg. ouf rotation clockwise.

0 Likes

Anonymous
Not applicable

You want N to be pointing to the right?

 

2015-01-26_14-03-58.jpg

0 Likes

Anonymous
Not applicable

should be down in that shot

0 Likes

Anonymous
Not applicable

Try this procedure:

 

1.)  Rotate the Viewcube to your desired orientation.

2.)  Select to open up the Viewcube Options

3.)  Select to set the current view to be the HOME view.

 

2015-01-26_14-08-14.jpg

0 Likes

Anonymous
Not applicable

that rotates the entire model

0 Likes

Anonymous
Not applicable

Then you'll have to rotate the model area to how you want it, in the orientation you want it.

 

Anonymous
Not applicable

will the odel rotation change coordinates of the model elements?

0 Likes

Anonymous
Not applicable
Accepted solution

Yes it will change the model coordinates.  Be sure to rotate around the origin point, or the point that needs to be the same.

(Example, rotate with 0,0,0 as your base point.)