Steelplus will not aut load on start.

[Anonymous]

I installed SteelPlus and load it via CUILOAD browse to its location and click "Load" everything works perfect.  I close CAD and on re-open I have to manually load SteelPlus again, anyone know how to get this to auto load like it should?

Thank you in advance

-N

[john.vellek]

Hi @Anonymous,

I see that you are visiting as a new member. Welcome to the Autodesk Community! 

Is it the menu that is not loading automatically? Or is it a set of executables?

Perhaps once you have it loaded a WSSAVE might add it to your workspace. Here is an article that also describes a process to remedy menus that are not being retained in the workspace.

Please select the Accept as Solution button if my post solves your issue or answers your question.

[john.vellek · Accepted solution]

Hi @Anonymous,

I am checking back to see if my post helped you with your problem. Please add a post with how you decide to proceed and your results so other Community members may benefit.

Please hit the Accept as Solution button if a post or posts solves your issue or answers your question.

[Anonymous]

Almost 3 years on a reply, but better late than never?  Yes your solution was helpful thank you!  I didn't have Email notification set to on and I only visit when troubles arise 🙂