polyline second position

[Anonymous]

I start a polyline and input the coordinates for the next position . The polyline does not go to the required coordinate but shoots way off . What polyline settings must be in place to rectify this issue? 

Nigel

[whitney_jeff]

Do you have any running OSNAPS set?  It's possible that the coordinates you input are close enough to an object that the OSNAP overrides take precedence

[cadffm]

Hi.

only Polylines?

Or Lines too?

Then i guess you are new to dynamic input (is dynmode>0 ?)

and your dynpicoords are set to relative input.

?