Need help with an Auto CAD error

[itzidemiguel]

Hi everyone, I need help, I don´t understand why this happens to me, if anyone know how can I fix it, PLEASE let me know!!!! I can't work like this

[Washingtonn]

Check your OSNAP settings.  It looks like you have Midpoint selected.

[cadffm]

Hi,

It's working fine. Acad detect the midpoint as next snap point.

You trying to snap the perpenticular point, make sure it is turned ON.

[itzidemiguel]

But It also happens with the endpoints, should I turn both off?

[paullimapa]

As others have replied, if you have running object snaps turned on, coordinate selection would be impacted.

You can temporarily disable running object snaps by pressing the F3 button.

Or you can toggle from one object snap setting to another by pressing the Tab key.

Give these a try.

[itzidemiguel]

Ohh ok, I didn't know that, thank you sm!

[itzidemiguel]

I'll try that too, thank you!

[Kent1Cooper]

---

@cadffm wrote:

....

You trying to snap the perpenticular point, make sure it is turned ON.

---

It could be PERpendicular if we were looking at a 3D situation from an oblique point of view.  But we can see from the UCS icon at lower left, and in the status line, that this is an isometric 2D drawing.  PERpendulcar is not an appropriate Osnap mode to use for the location they're after.  Having INTersect mode on, with Polar Tracking enabled [F10], can latch onto it.

[Valentin_CAD]

@itzidemiguel ,

Try using "Object Snap Tracking".