Community
995 Views, 3 Replies
How can i setup Drawing objects(Floor Plan) properly and start an Isometric Drawing to draw Pipes?
How can i setup Drawing objects(Floor Plan) properly and start an Isometric Drawing to draw Pipes?
Perhaps creating new drawing from "acadiso3D.dwt" will solve Your question. Hint: turn on Ortho mode by pressing F8. Open AutoCAD and follow three steps shown on picture below.
Perhaps creating new drawing from "acadiso3D.dwt" will solve Your question. Hint: turn on Ortho mode by pressing F8. Open AutoCAD and follow three steps shown on picture below.
Sorry for lack of picture. I don't know why I forgot to attach it. Steps to create new drawing: 1. Click on upper left corner of AutoCAD 2. Click "New" 3. Choose "acadiso3D.dwt" End 🙂
Sorry for lack of picture. I don't know why I forgot to attach it. Steps to create new drawing: 1. Click on upper left corner of AutoCAD 2. Click "New" 3. Choose "acadiso3D.dwt" End 🙂
You can start by (in modelspace) typing SNAP > S > and select I for ISO mode. (Do the opposite to get back to ortho mode)
While you are drawing you can press F5 to toggle between TOP, LEFT, RIGHT.
You might also want to hit F9 to turn off snap.
HTH
Regards,
DJ
You can start by (in modelspace) typing SNAP > S > and select I for ISO mode. (Do the opposite to get back to ortho mode)
While you are drawing you can press F5 to toggle between TOP, LEFT, RIGHT.
You might also want to hit F9 to turn off snap.
HTH
Regards,
DJ
Forums Links
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
