I can't fillet. Shows failure while filleting

[Anonymous]

Please can anyone assist me in getting the attached file filleted? I'm trying to design a logo for a watch store called watchmen. I can't seem to get it correctly. Any help would be greatly appreciated. And also any suggestions on the material I should apply.

[parkr4st]

radius?  .5 doesn't work, .25 or .34  or.4 or .45 does work   .495 doesn't

[Anonymous]

I've tried it too, it just doesn't work, some edges can be filleted, while others can't. And I don't know why. Can you try it if you can come up with something?

[Alfred.NESWADBA]

Hi,

I would not use SPLINES for the contour of this logo, recreate the contour with polylines and all will work better.

- alfred -

[S.Faris]

Please highlight the edges that can't be filleted so that it will be easy for us to understand what the issue might be . That will help us save a lot of time 

[imadHabash]

it seems fine with me ... try FILLETEDGE command ( change radius option value ) . make your model orientation as shown below then active FILLETEDGE command and select edge corners then double enter .