Edgesurf
Hi,
you might try command _SURFNETWORK instead.
- alfred -
Alfred NESWADBA
ISH-Solutions GmbH / Ingenieur Studio HOLLAUS
www.ish-solutions.at ... blog.ish-solutions.at ... LinkedIn ... CDay 2026
------------------------------------------------------------------------------------
(not an Autodesk consultant)
Also the LOFT command (2 opposite section lines, 2 Guides) works well.
Jürgen Palme
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
I believe the issue is that these are 2D Polylines and don't exactly contain and values for Z. They have an elevation, but that appears to not be what the edge surf command wants.
I was able to convert your 2D Polyline to Splines using SPLINEEDIT.
All you have to do is invoke the command and select the object and it converts it, then just exit the command.
After than they have a Z value and EDGESURF seems to work fine.
CADnoob
EDGESURF will also work if you use 3DPolylines instead of the 2DPolylines.
Jürgen Palme
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
