Community
AutoCAD Forum
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

drawing problem

4 REPLIES 4
Back to AutoCAD Category
Back to Topic Listing
Reply
Message 1 of 5
Anonymous
275 Views, 4 Replies
‎09-16-2014 12:47 AM

drawing problem

Anonymous
Not applicable
‎09-16-2014 12:47 AM

i using autocad 2014,system requirment ok

but when i working in this attached dwg. than too much slow,

plz tell how i can repair this file,i already used soe command as purge,audit,recover,w block ect but still problem is there so tell me

GROUND FLOOR RCP.rar
0 Likes
‎09-16-2014 12:47 AM

drawing problem

i using autocad 2014,system requirment ok

but when i working in this attached dwg. than too much slow,

plz tell how i can repair this file,i already used soe command as purge,audit,recover,w block ect but still problem is there so tell me

GROUND FLOOR RCP.rar
Report
0 Likes
Reply
4 REPLIES 4
Message 2 of 5
Anonymous
in reply to: Anonymous
‎09-16-2014 01:40 AM

Anonymous
Not applicable
‎09-16-2014 01:40 AM

try delete all annotation scale.

 

0 Likes
‎09-16-2014 01:40 AM

try delete all annotation scale.

 

Report
0 Likes
Reply
Message 3 of 5
Anonymous
in reply to: Anonymous
‎09-16-2014 01:46 AM

Anonymous
Not applicable
‎09-16-2014 01:46 AM

this can delete annotation scale by all drawings in a folder

 

http://www.cadforum.cz/cadforum_en/tips.asp?t=DBXremSL

0 Likes
‎09-16-2014 01:46 AM

this can delete annotation scale by all drawings in a folder

 

http://www.cadforum.cz/cadforum_en/tips.asp?t=DBXremSL

Report
0 Likes
Reply
Message 4 of 5
Anonymous
in reply to: Anonymous
‎09-18-2014 12:20 AM

Anonymous
Not applicable
In response to Anonymous
‎09-18-2014 12:20 AM
how i will delete this annoauto scale with command
0 Likes
‎09-18-2014 12:20 AM

how i will delete this annoauto scale with command
Report
0 Likes
Reply
Message 5 of 5
Anonymous
in reply to: Anonymous
‎09-18-2014 01:38 AM

Anonymous
Not applicable
In response to Anonymous
‎09-18-2014 01:38 AM

You can use SCALELISTEDIT on one drawing for testing first.

0 Likes
‎09-18-2014 01:38 AM

You can use SCALELISTEDIT on one drawing for testing first.

Report
0 Likes
Reply
Reply

Forums Links

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

AutoCAD Inside the Factory


Autodesk Design & Make Report

Report a website issue