I am working on existing drawing previously created. I have moved the dimensions into model space. I now cannot grab a handle and change the dimension. it immediately unselects it. not on locked layer or constrained. I copied lines and dimensions from another drawing and pasted and can move them fine.
Sounds like pickfirst and grips are both set to 0. If that is not the issue, attach a copy of your drawing with only a single non-functional dimension.
I hope you are posting by using the forum interface. If so, under the body, where you write your message are other controls and buttons. Look for the attachments section and push the browse button.
after looking at looking at model form all directions, I now can see that the object lines at on the Z0 plane but if I look from front or left/ right view I can see that the dimensions are on a plane below 0 and at slight angle. I am not sure how to fix but I do now have an idea on how it happened. Sometimes when I move a view sideways in a viewport I push the middle button on mouse to pan then I hold shift key down to make sure it moves directly sideways and doesn't move up or down in the viewport. however I have found that if you hold down shift key first then middle mouse key it actually starts to orbit. I must have tilted the model just slightly (not enough to notice) and then started to dimension. and when I changed the dimensions from paper to model space it threw them below Z0 axis
