Ctrl-Click xref layer in filter

[AndrewBrownie]

For some reason in AutCAD 2015 i can not shift-click or Ctrl-click xref layers in the filter section of the layer manager. See attached

Thanks

[wispoxy]

Works fine for me. Might be a registry error, looking further into the matter.

[VinodBalasubramanian]

Dear Andrew,

Can you able to try resetting your AutoCAD to defaults and see whether it helps to get the shortcut key back. If you have any customizations in AutoCAD, please make sure to back them up before checking.

http://knowledge.autodesk.com/article/How-to-reset-AutoCAD-to-defaults

Hope it helps.

[wispoxy]

I believe this reply is for you abrown

[VinodBalasubramanian]

Yes Andrew it was for Andrew Brown. Thanks for confirming it.

[AndrewBrownie]

Unfortunately this has not resolved my problem

Thanks

Andrew

[VinodBalasubramanian]

Thanks Andrew. Can you try the following.

1. Type "LAYERDLGMODE" in command bar
2. Set variable to "0"

Then try and see whether it helps or not. If not I could take a quick remote on your machine to troubleshoot the problem.

[AndrewBrownie]

Hi there,

unfortunately that also didn't work

[VinodBalasubramanian]

Can we have a quick remote on your machine tomorrow. Let me know your convenience on the timing.

[VinodBalasubramanian]

Hi,

Good day to you.

Just wanted to check with you for an update. Please let us know, if you need further assistance.

We will be glad to assist you further.