Cannot hatch due to unenclosed boundary?

[htoolwepawk]

Hi,

I am attempting to hatch this road, the boundaries in red, as i have done successfully to the road above it. However, i keep getting this message that the area is not enclosed however i have joined the two points using the endpoint in snap, so it should be closed? Autocad has highlighted the areas where the gaps are, and even in places where i am not trying to hatch, i have attempted to close them but its not working? 

[Tomislav.Golubovic]

If you zoom right in to those red circles, are they definitely connected?

[htoolwepawk]

Hi, this is the closest i can zoom into it 😞

[htoolwepawk]

actually this si the closest i can get

[Tomislav.Golubovic]

Can you upload the file here?

[htoolwepawk]

okay, here is the drawing file 

[Tomislav.Golubovic · Accepted solution]

Mine works fine on my end.

Zoom out until you can see the whole thing you want to hatch, then click inside the area and it'll hatch.

[htoolwepawk]

It works! Thanks you're awesome