Can't select on the line gap

[Anonymous]

 Hey, 

I'm using Autocad 2016 and LTGAPSELECTION is an unknown command.

As the tittle says, when i try to select on the gap of the line, it just go through, without select the line needed. Any sugestion?

[TheCADnoob]

I believe that was not a part of the program until release of 2017

https://jtbworld.com/autocad-2017

[ReneBogersREBO]

LTGAPSELECTION is available from version 2017!

Try turning off hardware acceleration trough GRAPHICSCONFIG command

[Anonymous]

You mean that there is no way I can do this on this version? Click the gap to select the line?

---

[Anonymous]

Already tried it, doesn't work

[ReneBogersREBO · Accepted solution]

If that doesn't work, than I am afraid it's not possible... only thing I can think of is to bigger the selection box, but I can imagine thats not what you wanna do!

Form version 2017 it is possible if I am right.

(I don't have AutoCAD here anymore, so can't check it out, only Revit on my machine :s)

A crossing maybe could also work I guess.

Crossing is, when your crosshairs are dotted instead of continuous (dotted or continuous depens on the movement bottomleft to upper right, or upper right to bottom left).

[Patchy]

Just like newer vehicles come with airbag, old one have none and you buy new vehicles if you want airbag.

[TheCADnoob]

Not unless it was released with a patch later in the year, but i dont think they did that with this command. You can make sure your version is up to date and see if it in there, but i dont remember them pre-releasing that command. 

[RobDraw]

---

@Anonymous wrote:

You mean that there is no way I can do this on this version? Click the gap to select the line?

---

---

Correct.