Baseview custom UCS
A better solution than what I first posted, below, is to create a top view, then rotate that view, then project the view from that, then put the top view on a non-plot layer if needed.
I have a kludge of a solution involving pulling a section view off the face of the angled surface, rotating that view. If I don't need the top view I place that on a layer that doesn't plot and change the scale to something small, change the section (auxiliary view) back to the scale needed. I told you it was a kludge.
There is a cuStom option under Orientation but it doesn't do anything, so I am assuming if Autodesk fixed that we would have a way to do this?
GrantsPirate
Piping and Mech. Designer
Always save a copy of the drawing before trying anything suggested here.
----------------------------------------------------------------------------
If something I wrote can be interpreted two ways, and one of the ways makes you sad or angry, I meant the other one.
Hi,
It would be appropriate to create a NEW message and include the details of your request.
Imad Habash
