AutoCAD 2023: How to initiate “block editor” for blocks inserted in a table?

[JamaL9722060]

AutoCAD 2023: How to initiate “block editor” for blocks inserted in a table?

I couldn’t figure out how to initiate “block editor” for blocks inserted in a table as the “block editor” doesn’t appear when right clicking the block inserted in a table

[RobDraw]

If you know the name, I believe you can select it from the list inside the block editor. (Sorry, I can't test ATM.)

As an option, just make a new insertion of the block and edit from there.

[JamaL9722060 · Accepted solution]

I got the answer. The “design center” tool offer accessing blocks inserted in a table

[ВeekeeCZ]

Whats?

Pick a cell to know a block name, hit BEDIT icon or command, pick a block by its name to edit...

[JamaL9722060]

As per the screenshots below, the “block editor” icon on the “block” group initiates the “edit block definition” but not “block editor”

[ВeekeeCZ · Accepted solution]

Pardon my ignorance, but how is it different? It's just a different label, both edit a block definition.

Sure, you need to hit OK to get into the Block Editor.

[JamaL9722060]

Right. Pressing OK does initiate the “block editor” as per the screenshots below.

However, both approaches fails to initiate the “block editor” by directly right clicking the block inserted in a table the same way it works when the block is not inserted in a table

[RobDraw]

You're welcome. 

[ВeekeeCZ]

If you do these edits often, you can use this LISP. Just pick a block when no table is active.

(defun c:TBEdit ( / e)
  (if (setq e (cadr (reverse (last (nentsel "Select block within a table: ")))))
    (command "_.bedit" (cdr (assoc 2 (entget e)))))
  (princ)
  )

[JamaL9722060]

Thank you for the help

best

Jamal